GS1 Composite
Support for the parameters in the table is labeled as follows:
ü = Parameter is supported and available via the Scanner Options tab in the device profile.
X = Parameter is not supported on this device.
NYI = Not Yet Implemented. These parameters are considered unsupported, though they can (with knowledge) be set via the CCI or advanced settings.
A730 and A730x support for symbologies and parameters may differ. Refer to the table below for details.
The registry keys in the table below are located under:
[HKEY_LOCAL_MACHINE\Software\xxx\Imager\GS1 Composite]| Registry Key | Default Value |
A730 | A730x | Description |
|---|---|---|---|---|
| CompositeAB |
0x0 | ü | ü | Enables GS1 Composite with a CC-A or CC-B (Micro PDF417) 2D component. |
| CompositeCA |
0x0 | ü | ü | Enables GS1 Composite with a CC-C (PDF417) 2D component. |
| Composite |
0x0 | ü | ü | Enables emulation of the GS1-128 symbology. |
| Composite |
0x0 | ü | ü | Ignores the 2D portion and only transmits the 1D barcode. |
| Composite |
0x0 | ü | ü | Disable transmission of AIM identifier. |
| Composite |
0x2a | ü | ü | A single character inserted before the barcode data to indicate the symbology. |
| Composite |
0x2a | ü | ü | A single character inserted before the barcode data to indicate the symbology. |
| UPCAndEAN |
0x2 | ü | ü | Decode mode for EAN/UPC composites, where 0 = never linked (only EAN/UPC transmitted), 1 = always linked (2D component required), and 2 = autodiscriminate. |
| CompositeAB |
G0 | ü | ü | User-defined symbology identifier. Range is 0-4 characters. |
| CompositeC |
G1 | ü | ü | User-defined symbology identifier. Range is 0-4 characters. |