Headset Functions and LED Patterns for SRX

Headset Function User Action Headset Mode LED Pattern Tone
Power On Hold the Plus (+) and Minus (-) buttons for one second Headset powers on and searches for the previously-connected device. No new pairing takes place. Quick flutter Two high-pitched tones
Power Off Hold Plus (+) and Minus (-) buttons for three seconds when headset is powered on Headset is powered off and cannot be used to perform work Solid blue, then turns off.

Do not remove the battery until the LED is off.

 Two low-pitched tones
Increase volume Press the Plus (+) button N/A N/A Current audio gets louder
Decrease volume Press the Minus (-) button N/A N/A Current audio gets softer
Force disconnect for manual pairing in low power mode Hold the Plus (+) and Minus (-) buttons for four seconds Headset disconnects current pairing and enters low power pairing mode

Headset attempts to pair with the nearest un-paired Bluetooth device. Previous pairing erased from headset's memory.

Constant quick flash: four flashes per second (50 ms on, 200 ms off) No tone when entering mode. Three ascending tones upon pairing with a device
Switch to high power pairing when pairing in low power mode has failed With headset in pairing mode, hold the Plus (+) and Minus (-) buttons for seven seconds Headset enters high power pairing mode

Headset attempts to pair with the nearest un-paired Bluetooth device. Previous pairing erased from headset's memory.

This mode is recommended when pairing an SRX headset with a handheld device

Honeywell does not recommend this pairing mode for Talkman devices. This mode greatly increases the likelihood that your headset pairs with the wrong device.

 Constant flash in which LED stays lit longer: about two flashes per second (350 ms on, 50 ms off) No tone when entering mode. Three ascending tones upon pairing with a device
Lost connection:
  • A previously-paired device is not detected by the headset at power on
  • A paired device is powered off
  • Low Power or High Power Pairing modes fail to pair with a device within 60 seconds
 N/A

The headset cannot find an un-paired Bluetooth device within range.

Headset remains in this mode for 10 minutes while it waits for a previously-paired device to come within range. After 10 minutes of no activity, the headset powers off.

 Repeating pattern of three quick flashes, then off for about a second. Three descending tones when the connection to the master device is dropped
Low Battery N/A Headset automatically enters this mode when the battery's remaining charge reaches a minimum threshold. Constant very quick flutter (about 10 flashes per second).
When the LED is blinking in Low Battery mode, no other LED pattern is displayed unless both buttons are held to power off the headset.
 No tone.

Voice prompt: "Headset battery is getting low," or "Headset battery is getting low. Change headset battery now."